Description For 2.0 MegaMouth reels: Ensure uninterrupted bowfishing adventures by keeping an ample supply of extra line readily available in your boat. With the custom line spool designed for 2.0 MegaMouth reels, you can effortlessly swap out your old spool, reassemble the reel, and be fully prepared to continue shooting fish. It’s important to note that this line spool is exclusively compatible with the 2.0 MegaMouth reel model. Identifying the compatibility of your reel is straightforward. Look for the “2.0” marking near the logo on the outer cone of the reel to confirm that it is a 2.0 model. Reels without this marking are considered the original version. Alternatively, you can remove the front assembly and check the type of bearing present. A brass bearing indicates a 2.0 reel, while a steel and black bearing indicate the original version. Replacement Instructions Remove the hex set torque rod by loosening the set screws on the front of the picatinny tube and pull torque rod out. Twist cone counterclockwise and pull to remove. Unthread front end cap nut counterclockwise. Pull off the front line deflector being careful to retain all 3 boss springs. Remove the front transmission e-clip by hand or with a pliers. Pull off the rear line deflector. Remove the entire spool of line and brass bearing. Remove the old brass bearing from the old line spool and reuse. Insert old brass bearing into new line spool. Install new line spool with the grooved bottom side down and the smooth surface up.
